Note: To protect the privacy of our members, e-mail addresses have been removed from the archived messages. As a result, some links may be broken.

Lesson Plans


Re: metal tooling question - Rebecca

From: ARTISOK
Date: Sat Jan 15 2000 - 19:29:59 PST

  • Next message: Maahmaah: "Re: 5yr old and drawing"

    Rebecca,
     Although I teach at an elementary level- I have successfully used the metal
    foil for etchings on several occasions. (only fifth graders) Buy the 38 gauge
    because it is the easiest to work- not too hard. It comes in a variety of
    colors, depending on the outcome you want - gold, silver, copper is really
    nice. I cut some pieces of foam core (it gives enough so the metal will move
    ) and use this as the working surface.
    I always make sure the edges are wrapped around the foam-as the metal can CUT!
    We usually mount them on another piece of board and put mattes on them since
    they are small- Can't afford huge pieces - They turn out very nice with some
    great textural effects.
    Hope this helps,
    LaDonna aka artisok 

    ---

    This archive was generated by hypermail 2b29 : Sat Jan 15 2000 - 19:31:14 PST